• 2026-07-22 18:56:18
• admin

When formulating a water-based acrylic pressure-sensitive adhesive for labels, Tg is usually one of the first parameters we set. It indicates whether the dry adhesive film will behave relatively soft or firm at a given temperature and influences initial tack, peel adhesion, holding power, low-temperature performance and adhesive ooze. However, Tg alone does not determine whether an adhesive is sui...

• pressure sensitive adhesive Tg
• removable label adhesive formulation
• label adhesive Tg

• 2026-08-05 17:59:28
• admin

Choosing a water-based resin should begin with the application, not with viscosity, solids content, or price. Products with similar technical data can behave very differently in production. A resin may work well on paper but show weak adhesion on plastic film. A coating may form properly under heated drying but remain tacky at room temperature. A low-viscosity polyurethane dispersion may look too ...

• water-based resin
• Polyurethane dispersions
• Acrylic emulsions

• 2026-08-28 17:54:10
• admin

Printing problems on plastic film do not always come from the same part of the process. Ink may shrink immediately after transfer. A printed layer may look normal but fail a tape test after drying. Some problems only appear after water exposure, rubbing or when the press reaches normal production speed. During troubleshooting, it is useful to record when the defect first appears before changing se...

• plastic film printing problems
• film printing troubleshooting
• water-based printing primer