• 2026-08-05 17:59:28
• admin

Choosing a water-based resin should begin with the application, not with viscosity, solids content, or price. Products with similar technical data can behave very differently in production. A resin may work well on paper but show weak adhesion on plastic film. A coating may form properly under heated drying but remain tacky at room temperature. A low-viscosity polyurethane dispersion may look too ...

• water-based resin
• Polyurethane dispersions
• Acrylic emulsions

• 2026-08-11 18:51:37
• admin

As global environmental regulations such as EU REACH and OEKO-TEX® Standard 100 become increasingly stringent, traditional solvent-based PU systems face growing restrictions in protective glove manufacturing. With advantages such as low VOC emissions and no DMFa residue, waterborne polyurethane (WPU) emulsions are rapidly becoming a key choice for glove manufacturers transitioning from solvent...

• waterborne polyurethane dispersion
• industrial glove coating
• WPU for gloves

• 2026-09-03 15:43:32
• admin

Poor surface smoothness, low gloss, and microscopic pinholes may occur during the spraying and baking of waterborne PTFE non-stick coatings. These defects can allow steam, fats, and corrosive substances to penetrate the coating over time, increasing the risk of blistering, peeling, and reduced non-stick performance. Why Pinholes May Form Pure PTFE has extremely high melt viscosity and limited flow...

• PFA dispersion
• PTFE coating pinholes
• PFA modified dispersion