Color material gives printing rich and colorful colors,Connecting material as the carrier of color, also as a binder to make the color fixed on the substrate surface; Secondly, as a binder, the pigment can be fixed on the substrate surface to achieve the purpose of displaying text, image, marking and decoration. In order to get high quality ink, we must use high quality connecting material.2. Diluent can make the ink thin, increase the fluidity of the ink, while reducing the viscosity of the ink.Remove adhesive, also known as adhesive, it can reduce the viscosity of ink, while not affecting the ink body bone; The purpose of diluent is to dilute the color of ink, also called diluent; Anti-drying agent (antioxidant) can delay the oxidative polymerization process of dry oil; Preservatives can prolong the storage time of water-based ink; Uv absorbers can improve the sun resistance of prints. 3.Pigments and dyes Pigments and dyes are very fine colored substances. Dyes are generally soluble in the binder. Printing ink commonly used for inorganic pigment filler organic dyes and dyes.

1.After besmear brushes its film sex is good, the surface after coating solidifies can form uniform rubber shape elastomer, and this kind of coating suits special-shaped structure very much. 3.It is very convenient when construction, suit any besmear to brush means, be it wet surface also can construct. 4.Coating itself is absolutely environmental protection, non-toxic without any smell, the use of very convenient. Method one: it is suitable for any besmear brush way, besmear brush gush is in use first water-proof agent and water stir evenly by proportion, in the container that is loaded spray, undertake spray.Try not to use in the near rainy season, or the temperature is below 0 degrees, the construction of the confession must be dry. 2.Avoid mixing with other paints and coatings. 3.When besmear is brushed, the wall asks dry level off clean, if have dirt or mildew to erode etc. circumstance, must clean up first. welcome you to consult, this is our email sales@sinogracechem.com

The bonding of objects is achieved by the tension between the polymers in the glue.When the moisture in the glue disappears, the polymer in the glue depends on the pull force between each other, tightly combining two objects together.In the use of glue, too much glue will make the polymer in the glue crowded together;The polymers crowd each other so they don't form the strongest attraction to each other.welcome you to consult, this is our email sales@sinogracechem.com

◆ The procedure of bonding process:◆ The adhesive surface should be evenly coated to ensure infiltration, as far as possible to avoid bubbles, due to the porosity of the adhesive strength greatly reduced, resulting in degumming.Attention should be paid to the alignment of the position, not staggered, can be pressurized, air exclusion, make it close contact. Time is three important parameters of curing process and the change of each parameter has direct influence on bonding strength, (each kind of adhesive has a specific curing temperature and time), curing at a certain pressure, it should be said that it is necessary for all Water, avoid bubble pores and make the adhesive layer uniform and fixed position.Whether by chemical reaction or physical action to complete the adhesive curing, it takes a certain amount of time, in order to cure completely get the adhesive strength, must ensure that there is enough curing time,(this is usually referred to a certain amount of time to make the adhesive to reach the final adhesion).