• 2026-06-01 18:20:08
• admin

In ceramic fiber paper production, the sheet does not always fail at the forming stage. Sometimes the wet sheet looks acceptable, but problems appear later during drying, winding, or cutting. For example, the paper may feel weak after drying. The edge may crack during slitting. Fine fiber dust may come off the surface. In continuous production, these small problems can quickly lead to material los...

• ceramic fiber paper dusting
• ceramic fiber paper cracking
• binder for insulation paper

• 2026-07-16 15:53:46
• admin

Waterborne polyurethane dispersions, commonly known as PUDs, may appear milky white, translucent, or slightly bluish in the liquid state. This difference is mainly related to particle size, particle size distribution, and how strongly the dispersed particles scatter visible light. In general, milky dispersions scatter more light, while finer dispersions allow more light to pass through. However, a...

• PUD
• polyurethane dispersions
• waterborne polyurethane

• 2026-08-05 17:59:28
• admin

Choosing a water-based resin should begin with the application, not with viscosity, solids content, or price. Products with similar technical data can behave very differently in production. A resin may work well on paper but show weak adhesion on plastic film. A coating may form properly under heated drying but remain tacky at room temperature. A low-viscosity polyurethane dispersion may look too ...

• water-based resin
• Polyurethane dispersions
• Acrylic emulsions

• 2026-08-11 18:51:37
• admin

As global environmental regulations such as EU REACH and OEKO-TEX® Standard 100 become increasingly stringent, traditional solvent-based PU systems face growing restrictions in protective glove manufacturing. With advantages such as low VOC emissions and no DMFa residue, waterborne polyurethane (WPU) emulsions are rapidly becoming a key choice for glove manufacturers transitioning from solvent...

• waterborne polyurethane dispersion
• industrial glove coating
• WPU for gloves

• 2026-08-21 17:00:20
• admin

A good hot stamping result depends on more than the foil it self. The adhesive layer affects transfer quality, edge definition, adhesion, drying, and storage stability. When selecting a water-borne adhesive for hot stamping foil production, start with three points: the substrate, the coating process, and the stamping temperature. Check the Substrate Hot stamping foil may be used on paper, OPP, PET...

• PolyurethaneAdhesive
• Adhesive for Hot Stamping Foil
• modified polyurethane adhesive