• 2026-07-10 13:22:24
• admin

Resin is the main film-forming component in printing ink. It influences pigment dispersion, adhesion, drying speed, gloss, flexibility and resistance. There is no universal resin for every ink. The right choice depends on the ink system, substrate, printing method and the conditions the printed product will face after printing. Quick Resin Selection Guide Ink typeCommon resin choicesMain advantage...

• printing ink resin
• resin for printing ink
• printing ink binder

• 2026-07-22 18:56:18
• admin

When formulating a water-based acrylic pressure-sensitive adhesive for labels, Tg is usually one of the first parameters we set. It indicates whether the dry adhesive film will behave relatively soft or firm at a given temperature and influences initial tack, peel adhesion, holding power, low-temperature performance and adhesive ooze. However, Tg alone does not determine whether an adhesive is sui...

• pressure sensitive adhesive Tg
• removable label adhesive formulation
• label adhesive Tg

• 2026-08-11 18:51:37
• admin

As global environmental regulations such as EU REACH and OEKO-TEX® Standard 100 become increasingly stringent, traditional solvent-based PU systems face growing restrictions in protective glove manufacturing. With advantages such as low VOC emissions and no DMFa residue, waterborne polyurethane (WPU) emulsions are rapidly becoming a key choice for glove manufacturers transitioning from solvent...

• waterborne polyurethane dispersion
• industrial glove coating
• WPU for gloves

• 2026-08-21 17:00:20
• admin

A good hot stamping result depends on more than the foil it self. The adhesive layer affects transfer quality, edge definition, adhesion, drying, and storage stability. When selecting a water-borne adhesive for hot stamping foil production, start with three points: the substrate, the coating process, and the stamping temperature. Check the Substrate Hot stamping foil may be used on paper, OPP, PET...

• PolyurethaneAdhesive
• Adhesive for Hot Stamping Foil
• modified polyurethane adhesive

• 2026-09-03 15:43:32
• admin

Poor surface smoothness, low gloss, and microscopic pinholes may occur during the spraying and baking of waterborne PTFE non-stick coatings. These defects can allow steam, fats, and corrosive substances to penetrate the coating over time, increasing the risk of blistering, peeling, and reduced non-stick performance. Why Pinholes May Form Pure PTFE has extremely high melt viscosity and limited flow...

• PFA dispersion
• PTFE coating pinholes
• PFA modified dispersion

• 2026-09-18 13:23:55
• admin

Does Your Textile Printing Paste Still Feel Sticky or Crack? This Water-Based PU Resin Combines Softness with High Elongation Manufacturers of textile prints and thick coatings for footwear materials may have encountered these frustrating problems: The printed paste remains sticky after drying and causes blocking when the fabrics are stacked. The coating cracks or peels after several washes. In co...

• Water-Based PU Resin
• Textile Printing Binder
• Waterborne Polyurethane for Textile Coating