• 2026-07-03 17:12:10
• admin

Adjusting a water-based acrylic resin formulation is rarely as simple as adding one new material. For example, increasing resin hardness may make the coating film more brittle. Reducing the glass transition temperature can improve low-temperature film formation, but it may also reduce heat resistance and blocking resistance. Increasing the amount of hydrophilic groups may improve emulsion stabilit...

• water-based acrylic resin
• acrylic resin modification
• water-based acrylic emulsion

• 2026-07-10 13:22:24
• admin

Resin is the main film-forming component in printing ink. It influences pigment dispersion, adhesion, drying speed, gloss, flexibility and resistance. There is no universal resin for every ink. The right choice depends on the ink system, substrate, printing method and the conditions the printed product will face after printing. Quick Resin Selection Guide Ink typeCommon resin choicesMain advantage...

• printing ink resin
• resin for printing ink
• printing ink binder

• 2026-08-05 17:59:28
• admin

Choosing a water-based resin should begin with the application, not with viscosity, solids content, or price. Products with similar technical data can behave very differently in production. A resin may work well on paper but show weak adhesion on plastic film. A coating may form properly under heated drying but remain tacky at room temperature. A low-viscosity polyurethane dispersion may look too ...

• water-based resin
• Polyurethane dispersions
• Acrylic emulsions

• 2026-08-21 17:00:20
• admin

A good hot stamping result depends on more than the foil it self. The adhesive layer affects transfer quality, edge definition, adhesion, drying, and storage stability. When selecting a water-borne adhesive for hot stamping foil production, start with three points: the substrate, the coating process, and the stamping temperature. Check the Substrate Hot stamping foil may be used on paper, OPP, PET...

• PolyurethaneAdhesive
• Adhesive for Hot Stamping Foil
• modified polyurethane adhesive

• 2026-09-03 15:43:32
• admin

Poor surface smoothness, low gloss, and microscopic pinholes may occur during the spraying and baking of waterborne PTFE non-stick coatings. These defects can allow steam, fats, and corrosive substances to penetrate the coating over time, increasing the risk of blistering, peeling, and reduced non-stick performance. Why Pinholes May Form Pure PTFE has extremely high melt viscosity and limited flow...

• PFA dispersion
• PTFE coating pinholes
• PFA modified dispersion

• 2026-09-18 13:23:55
• admin

Does Your Textile Printing Paste Still Feel Sticky or Crack? This Water-Based PU Resin Combines Softness with High Elongation Manufacturers of textile prints and thick coatings for footwear materials may have encountered these frustrating problems: The printed paste remains sticky after drying and causes blocking when the fabrics are stacked. The coating cracks or peels after several washes. In co...

• Water-Based PU Resin
• Textile Printing Binder
• Waterborne Polyurethane for Textile Coating