• 2026-08-01 10:23:15
• admin

When UV ink comes off during a tape test, the primer is often blamed first. However, poor adhesion can also result from the film surface, contamination, incomplete primer drying or incorrect UV curing. Here, “adhesion promoter” refers to a primer applied before printing. No single grade is suitable for every plastic film. Choose the Primer by Substrate PET and BOPET films often benefit from a prim...

• BOPP printing primer
• UV ink adhesion promoter
• water-based UV ink primer

• 2026-08-05 17:59:28
• admin

Choosing a water-based resin should begin with the application, not with viscosity, solids content, or price. Products with similar technical data can behave very differently in production. A resin may work well on paper but show weak adhesion on plastic film. A coating may form properly under heated drying but remain tacky at room temperature. A low-viscosity polyurethane dispersion may look too ...

• water-based resin
• Polyurethane dispersions
• Acrylic emulsions

• 2026-08-11 18:51:37
• admin

As global environmental regulations such as EU REACH and OEKO-TEX® Standard 100 become increasingly stringent, traditional solvent-based PU systems face growing restrictions in protective glove manufacturing. With advantages such as low VOC emissions and no DMFa residue, waterborne polyurethane (WPU) emulsions are rapidly becoming a key choice for glove manufacturers transitioning from solvent...

• waterborne polyurethane dispersion
• industrial glove coating
• WPU for gloves