Water-based wood lacquer can be used to
apply. The characteristics of the brush method is simple, easy to master, fast
coating speed, and can eliminate the brush method commonly seen bubbles and
brush marks and other shortcomings. This is because the paint left on the
surface of the wood is very thin and the pressure of the brush is high, which
makes the air in the wood grain and micro hole easy to be removed and
impossible to leave too much paint.
Wipe the silk wadding group that besmear USES
to ask to absorb fluid ability big, soft, do not drop fiber, after the group
becomes a group, use clear water bubble first wet, squeeze go to redundant
moisture, cannot drop water, ability dips in lacquer construction next. Wear
rubber gloves when operating. Most of the water-based paint is too viscous and
not suitable for direct rub, to add 10% ~ 30% of the tap water after
dilution.In order to exempt wood grain because of water bilge rise and rise
burr, had better besmear first dewaxing shellac is sealed bottom, after the
sand paper of 600# above burnish level off, brush lacquer of lacquer of
implement of water quality wood again.Old paint or wood surfaces suspected of
being greased must be sealed with shellac. When erasing, start from one side of
the woodwork and rub the entire line to the other side. At first the strength
should be light, not excessive extrusion, in order to avoid too much on both
sides of the silk Ⅲ extrusion coating, coating is too thick.Each line should be brushed
to the other side with slightly less pressure. Wipe line by line, each
waterborne wood paint line overlap 1 ~ 1. 5 cm wide. The corners of the silk
floss can be squeezed into the corresponding shape of rub. Because brush
besmear film is very thin, dry very fast, once discover leakage besmear or
paint quantity is overmuch want to deal with immediately.
Under normal circumstances half an hour after
the second coat can be wiped, winter can be extended to more than 2h. Each coat
should be sanded with 600# or more sandpaper and dusted with a damp cloth.
The rub of lubricious paint besmear method is
same, the lap that just wants to notice two lines of paint should be as far as
possible little, otherwise lap the color slants deep. After lubricious lacquer
goes up, had better cover a few varnish try to protect.
Furniture lacquer finishes besmear after
outfit, dry thoroughly, can undertake waxing polishing finally, make its
exterior more beautiful.