• 2026-08-21 17:00:20
• admin

A good hot stamping result depends on more than the foil it self. The adhesive layer affects transfer quality, edge definition, adhesion, drying, and storage stability. When selecting a water-borne adhesive for hot stamping foil production, start with three points: the substrate, the coating process, and the stamping temperature. Check the Substrate Hot stamping foil may be used on paper, OPP, PET...

• PolyurethaneAdhesive
• Adhesive for Hot Stamping Foil
• modified polyurethane adhesive

• 2026-09-03 15:43:32
• admin

Poor surface smoothness, low gloss, and microscopic pinholes may occur during the spraying and baking of waterborne PTFE non-stick coatings. These defects can allow steam, fats, and corrosive substances to penetrate the coating over time, increasing the risk of blistering, peeling, and reduced non-stick performance. Why Pinholes May Form Pure PTFE has extremely high melt viscosity and limited flow...

• PFA dispersion
• PTFE coating pinholes
• PFA modified dispersion