Silicone Coatings/Silicone Marble-Coating S-202

Description

As temperature resistance decorative non-stick coating, it could be used on outside of aluminum non-stick cookware. Please do complete applicability test for specific use.

Type

Silicone coating

Key features

-Eco-friendly and PFOA free

-Showing the effect of natural marble

-Easy application process, with bright color

-It’ s workable at 200℃, good chemical resistance

Typical properties

Product model： S-202A (Primer)

                           S-202B (Dot-1)

                           S-202C (Dot-2)

Recommended dosage： 10kg primer

                                         0.5kg Dot-1: 0.5kg Dot-2

Appearance： Light brown (Primer)

                        Light yellow (Dot-1)

                        Black (Dot-2)

Solid content (%)： 45±1 (Primer)

                               40±1 (Dot-1)

                               39±1 (Dot-2)

Viscosity (cp)： 30~50 (Primer)

                          10~16 (Dot-1)

                          10~16 (Dot-2)

Density (g/ml)： 1.20±0.20 (Primer)

                          1.25±0.20 (Dot-1)

                          1.25±0.20 (Dot-2)

pH： 8~11 (Primer)

         8~11 (Dot-1)

         8~11 (Dot-2)

Gloss (60° glossimeter)： 45-55

Film thickness (μm)： 15-25

Hardness： >3H (ZHONGHUA pencil)

Adhesion (1mm*1mm)： Grade 1

Application

-Outside of tensile aluminum and die-casting fry pan, wok, soup pot, etc. 

Storage and handling

-Available in 20 kg/ barrel or 30 kg/ barrel

-Store products in tightly closed original containers at 5-35℃

-Shelf life: 12 months from delivery date

-According to non-dangerous goods transport

How to use

1. Requirement on pre-treatment

-Firstly, apply high-temperature degreasing, then wash with 1%~3% NaOH solution (60℃) for more than 6 minutes, dry it after water rinsing.

-Blast with 80#~120# corundum to make the surface roughness reach 2.0μ~3.0μ, pay attention to sandblast evenly;

-Wash with 1%~3% NaOH solution(60℃) for more than 6 minutes, rinse with water.

-Wash with 1%~3% hydrochloric acid solution (60℃) for more than 6 minutes, rinse with water and dry.

2. Preparation of the coating

-Dispersion of coating: the coating must be fully dispersed before operation. Rolling the coating at the speed of 300rpm with rolling machine for 10mins at least.

-Coating filtration: filtrate the coating with screen (100mesh) before using.

3. Application

-The spraying environment should be dry, well-ventilated, no smoking and fire. We suggest using dedicated spray gun, elevated tank and curing oven.

-The air compressor should be degreased, dewatered and equipped with water oil separator before using.

-Adjust atomization and oil pump capacity of the spraying gun; make sure the unit is clean and flat.

-Leveling the coating at 150~180℃ after spraying, cure it at 280℃×10min. Keep the dry film thickness at the range of 15μm~25μm.

-In spraying process, keep stirring inside of the elevated tank, the size of spraying nozzle should be between 0.8mm~ 1.3mm, the pressure is about 3.5bar.

Non-stick Coating Type

↓ ↓ ↓ Please click product model for more informations